A New Tech Machinery Resource
The NTM UNIQ® Automatic Control System software has undergone a complete re-design and update based on your feedback. The latest software update will ensure user-friendliness, reliability, and safety remain top of mind when using your UNIQ controller. This latest release can be downloaded and easily updated on your machine controller via the SD card and […]
If the finished panel doesn’t look straight, has shape issues, or the legs are the wrong size, this could mean various things: Watch this video demonstration for the correct procedures for all of the above: (Even though this video demonstrates the steps on an SSQ II machine, the process is similar for the SSH and […]
If your shear is not cutting cleanly or straight, it could mean that your shear is out of alignment or not properly lubricated. Note: The shear is extremely dangerous and can cause serious bodily injury or death. For this reason, the machine is provided with a guard to prevent the operator from reaching into the […]
If the panel is a different length than you programmed into your PLC or EZ-Counter controllers, the most common cause of this issue is that the encoder may need to be adjusted. Make sure that your encoder is making contact with the material inside the machine and that the tension is set properly. Follow these […]
When the covers and guards are off of your machine, the machine will operate in “maintenance mode.” This is a normal safety function of the UNIQ® Automatic Control System and will not allow you to use any of the automatic functions (automatic run mode, automatic shear, programming recipes, etc.). When “maintenance mode” is activated, only […]